Select region
Submit
Water seal illustration

The challenges of a water-based system

A column of water was the original method used to control the amount of negative pressure transmitted to the chest. When disposable integrated drains were developed, this column of water was transformed into a suction control chamber (see illustration on left). The level of the water in this chamber determines the level of the negative pressure that is transmitted to the chest. Challenges with water-based systems are the noise of the bubbling and water evaporation. As water evaporates and the water level drops, the amount of negative pressure transmitted to the chest will also decrease. In addition, water-filled units take longer to set-up and if the drain is knocked over, the water can spill over into other chambers or onto the floor.

Dry suction regulator illustration

Self-regulating dry suction drains

Today's self-regulating dry suction drains use a small, adjustable regulator which is built into the drain. As long as there is adequate air flow from the wall suction source (which will be indicated on the drain) the regulator will automatically adjust to changes in the wall suction or the patient to maintain suction at the level set on the drain. It's also a quieter operating system compared to wet suction drains since there is no longer bubbling for suction control.  In addition, these drains provide a wider range of suction levels, from -10 cm H2O to -40 cm H2O and there's no evaporation to worry about.  If the drain is knocked over, it is less likely that water will spill between chambers and out of the drain. 

Dear user, You now see International fallback content. Getinge South East Asia does not review or control this content. It is possible that some of the products on Getinge international are not approved in your country. For more specific  information relevant for your region please contact us.